Wednesday, January 20, 2010

Garage Shelf How Can I Cut Angled Support Braces To Support A Shelf In My Garage?

How can I cut angled support braces to support a shelf in my garage? - garage shelf

I need to know the angle and length.

Posted by Rikki Sterner at 12:49 AM

6 comments:

T.J. said...

They sell all kinds of steel plate supports the local Home Depot and Lowe's. Some of them are very strong.

If you want to cut any angle and length works best with your platform. There is no rule that a certain length or angle must.

January 22, 2010 at 10:11 PM
lana s said...

measusre the width of the platform and the support that the time right to go under the platform sections. Measure it from the back of the platform, do not forget to add the width of the support and reduce that wants on the side of .=======

January 23, 2010 at 6:27 AM
f100_sup... said...

It depends on the weight of the platform to hold.

To shed light on the shelves, simply use a piece of the same width as the platform and cut pieces 2 45 * I enclose the lower part of the platform. (eg, use 1X8X6 8 'board, the final result in 45 *, then highlight and cut, cut and cut the squares, then along the remaining part. Use wood glue and screws to hold 2 triangles in the bottom of the platform uses a form of support for the hanging wall mounting platform.)

January 23, 2010 at 4:48 PM
David C said...

Sierra

January 23, 2010 at 11:43 PM
little eagle said...

If the timber supports to make it an easy way to do it,,,, put a 2 / 4 in the car, operated by 2 / 4, the wall under 2 / 4 on the platform of the desired length, take other 2 / 4, at the end of the platform next to the 2 / 4 and select a row,,, 2 / 4 done on the wall at the end of the same mark for a cut of 2 / 4,,, 2 / 4 are reduced must be long enough be to achieve the ends of 2 / 4 and is to be measures such as the 2 / 4, which will cut into time bound, make sure sure that the platform on the wall or no wall space to ensure it's still 90 degrees

January 24, 2010 at 9:37 AM
little eagle said...

If the timber supports to make it an easy way to do it,,,, put a 2 / 4 in the car, operated by 2 / 4, the wall under 2 / 4 on the platform of the desired length, take other 2 / 4, at the end of the platform next to the 2 / 4 and select a row,,, 2 / 4 done on the wall at the end of the same mark for a cut of 2 / 4,,, 2 / 4 are reduced must be long enough be to achieve the ends of 2 / 4 and is to be measures such as the 2 / 4, which will cut into time bound, make sure sure that the platform on the wall or no wall space to ensure it's still 90 degrees

January 24, 2010 at 9:37 AM

Post a Comment